Chapter 3 Adjustment Mode
[2] Adjusting inside stopper position
Set the operating range of the film arm in the lateral direction. Set the inside limit position as follows:
1） Loosen the screw of the inside stopper (near
side).
2） Push the film arm until the tip of the film arm
touches the film pull-out roller. Fix the inside
stopper in this position.
NOTE:
In the final check stage, the tip of the film arm and
the film pull-out roller may sometimes overlap by 1
– 2 mm after re-adjustment.
3）
djust the inside stopper in the back in a simila
procedure as for the near side.
4） Check that the film arm roller is in parallel with
the film pull-out roller.
Check parallelism while the film arm is being
pushed into the farthest inside at its “Near Side,
Center, and Back Side” positions.
Film arm inside
stopper
Inside
stopper
Film arm roller
Film pull-out roller
Push the arm to this
position.
Film pull-out roller
Film arm
Inside
sto
er
Near
side
Inside
stopper
Back
side
3-39
To Next Page
Loading...