HS-1RL User’s Manual Page 27
Barcode Suffix
Suffix characters are user-definable data characters that can be sent after scanned data.
It’s possible for the HS-1RL to enable and set a specific suffix for all scanned barcode data only.
Note: This Barcode Suffix will be separate from any set RFID suffixes or general suffixes.
Barcode Suffix On/Off
To enable or disable the barcode suffix, scan the appropriate code below.
Default = disabled.
Enable * Disable
Barcode Suffix Block String
Use the command SUFBBLK in combination with ASCII or hex characters to set the
specific Barcode Suffix string. See Appendix D for ASCII/hex conversion help.
Note: Hex characters must be preceded by \x to be recognized as hex instead of
ASCII and it’s not possible to interject a Carriage Return in the middle of the block string.
For instance, it’s possible to program a Suffix that starts with 123 (regular ASCII text),
then a Tab symbol (as hex 09) and then ABC (ASCII characters again), send the
following: SUFBBLK 123\x09ABC
Please contact JADAK if you need further help.
The default Barcode Suffix Block string is a Carriage Return (hex ‘0D’).
* Barcode Suffix Block \x0D
To Next Page
Loading...
