Jadak HS-1RL - Code 39; Code 39 Defaults; Code 39 On;Off; Code 39 Minimum and Maximum Length

To Next Page

To Previous Page

HS-1RL User’s Manual Page 44

Code 39

Code 39 Defaults

Code 39 On/Off

Scan one of the codes below to enable or disable Code 39. Default = Enabled.

* Enable Disable

Code 39 Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum

and maximum length. Default minimum length = 0. Default maximum length = 48.

The minimum and maximum length for this barcode can be set either by sending the serial

command shown under the barcodes below with a value between 0 and 48, or by building

a menu command bar code.

Code 39 Minimum Length Code 39 Maximum Length

Code 39 Full ASCII Conversion

Code 39 Full ASCII is a variant of Code 39 that pairs certain characters so it can include

the entire ASCII set. Default = Disabled.

Enable * Disable

Other manuals for Jadak HS-1RL