HS-1RL User’s Manual Page 41
Code 11
Code 11 Defaults
Set all Code 11 settings to their default configuration with this code/command.
Code 11 On/Off
Scan one of the codes below to enable or disable Code 11. Default = Disabled.
Enable * Disable
Code 11 Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length. Default minimum length = 4. Default maximum length = 55.
The minimum and maximum length for this barcode can be set either by sending the serial
command shown under the barcodes below with a value between 1 and 55, or by building
a menu command barcode.
Code 11 Minimum Length Code 11 Maximum Length
To Next Page
Loading...
