Jadak HS-1RL - UPC-E On;Off; UPC-E(0) Check Digit; UPC-E(0) Expanded Modeon;Off

HS-1RL User’s Manual Page 55
UPC-E On/Off
Scan one of the codes below to enable or disable UPC-E(0).
Default = Enabled.
* Enable Disable
UPC-E(0) Check Digit
The check digit is the last character and is used to verify data integrity. This digit is always
checked but it may be chosen whether or not to transmit it.
Default=Transmit
* Transmit UPC-E Check Do Not Transmit UPC-E Check
UPC-E(0) Expanded ModeOn/Off
UPC-E(0) Expanded Mode expands the UPC-E(0) code to the 12 digit, UPC-A format. Scan one
of the codes below to enable or disable UPC-E(0) Expanded Mode.
Default = Disabled.
Enable * Disable