HS-1RL User’s Manual Page 68
Appendices
Appendix A - Command Format
The HS-1RL accepts a wide range of configuration commands. Commands can be sent to the
imager wither by scanning menu bar symbol or via Serial commands sent from the host machine.
The HS-1RL command format is.
Send Command: #<parameter><space><argument><specifier>
Where:
Parameter: Command
Argument: Value to be set, if applicable
Specifier: Character to designate action to be taken.
All available commands are listed on the following pages as well as a brief description of what
the parameter choices mean. Some commands require further elaboration that can be found in
the relevant sections in the guide.
For example, the command to enable reading of Code 128 barcode symbols is
“128ENAB 1”. The full command to apply this setting to ROM is:
#128ENAB 1.
Throughout this manual, the serial command for each setting is shown directly below the
corresponding barcode menu symbol. Additionally, all commands are shown in table A1-2.
Upon reception of the special command “#HELP”, the imager will output all its commands serially
to the host computer, in the format shown in table A1-1. This is a very helpful way to see what
commands are supported by the firmware version that you are using, and to archive the imager
configuration.
To Next Page
Loading...
