HS-1RL User’s Manual Page 36
Auto Exposure
Allow the imager to control gain and exposure settings automatically.
Default = Enabled.
Disable * Enable
Maximum Exposure
Set the maximum allowable exposure for the unit between 1 and 7874.
Several commonly used Max Exposure menu command barcodes are included below. If a
different value other than those provided is needed, it can be set either by sending the serial
command EXP_MAX x (where ‘x’ is a value between 1 and 7874), or by building a menu
command barcode.
Default value = 100.
Setting examples:
Target White Value
Set the Target White Value within a range of 48 to 212.
Some menu command barcodes are included below. If a different value other than those
provided is needed, it can be set either by sending the serial command EXPTARG x (where ‘x’ is
a value between 48 and 212), or by building a menu command barcode.
Default value = 120.
To Next Page
Loading...
