HS-1RL User’s Manual Page 31
RFID Prefix
Prefix characters are user-definable data characters that can be sent before scanned data. It’s
possible to enable and set a specific prefix for all scanned RFID data only.
Note: This RFID Prefix will be separate from any set Barcode prefixes or general prefixes.
RFID Prefixes On/Off
To enable or disable RFID prefixes, scan the appropriate code below.
Default = disabled.
Enable * Disable
RFID Prefix Block String
Use the command PRERBLK in combination with ASCII or hex characters to set the
specific RFID Prefix string. See Appendix D for ASCII/hex conversion help.
Note: Hex characters must be preceded by \x to be recognized as hex instead of
ASCII and it’s not possible to interject a Carriage Return in the middle of the block string.
For instance, if you want the prefix to be [RFID], send: PRERBLK [RFID].
Default RFID Prefix Block string is: (R)
Example codes:
* RFID Prefix Block (R) RFID Prefix Block [RFID]
To Next Page
Loading...
