HS-1RL User’s Manual Page 40
Linear Symbologies
Codabar
Codabar Defaults
Set all Codabar settings to their default configuration with this code.
Codabar On/Off
Scan one of the codes below to enable or disable Codabar. Default = Enabled.
* Enable Disable
Codabar Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length. Default minimum length = 4. Default maximum length = 55.
The minimum and maximum length for this barcode can be set either by sending the serial
command shown under the barcodes below with a value between 2 and 55, or by building
a menu command barcode.
Codabar Minimum Length Codabar Maximum Length
To Next Page
Loading...
