HS-1RL User’s Manual Page 46
Code 93
Code 93 Defaults
Set all Code 93 settings to their default configuration with this code.
Code 93 On/Off
Scan one of the codes below to enable or disable Code 93. Default = Enabled.
* Enable Disable
Code 93 Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length. Default minimum length = 0. Default maximum length = 55.
The minimum and maximum length for this barcode can be set either by sending the serial
command shown under the barcodes below with a value between 0 and 55, or by building
a menu command barcode.
Code 93 Minimum Length Code 93 Maximum Length
To Next Page
Loading...
