Janome MB-7e - Replacing the X-Carriage Belt

51
Replacing the X-carriage Belt
1. Remove the spool stand, head set right cover and
left cover (see pages 4 to 6).
2. Loosen the setscrews A (2 pcs.) and remove the
X-carriage cover.
3. Shift the hoop supporter to the extreme left end.
Remove the setscrews C (2 pcs.) and the X-belt holder.
4. Loosen the setscrews B (2 pcs.) and shift the X-belt
pulley in the direction of the arrow.
5. Remove the E-ring and pull the X-belt pulley shaft to
remove the X-belt pulley.
6. Remove the setscrews D (2 pcs.) and drive pulley shaft
unit.
7. Replace the X-carriage belt.
8. Attach the parts removed in steps 3 to 6.
9. Adjust the X-carriage belt tension (see the previous
page).
10. Attach the parts removed in steps 1 to 2.
Setscrew A
X-belt holder
Setscrew C
X-belt pulley
Setscrew B
Hoop supporter
E-ring
X-belt pulley shaft
Drive pulley shaft unit
Setscrew D