Jetter JetMove D203 - Page 41

JetMove D203 5.1 Electrical Specification
Jetter AG 41
Power loss P
v
• Output stage: 50 W max.
• Logic circuit: 14 W max.
• Option -JC24X: 18 W max.
Weight, mating connectors
included
• JM-D203: 2,500 g
• Option -S1 (Safe Torque Off): 150 g
• Option -JC24X (controller): 300 g
Electrical Specification
NOTICE
Time between deactivating and activating the mains power supply
The time between switching off and on the power supply must be longer than 1.5
seconds. If this is not given heed to, the inrush current cannot be limited and thus
take on high values. As a consequence, the device can be destroyed, or the
external fuse is activated.
INFO 1
Cooling:
• The overtemperature protection is activated at 85 °C.
• The overtemperature alarm is activated at 80 °C.
• The duration for the peak current is measured at a starting temperature of
45 °C at the heat sink.
INFO 2
A line filter can supply several digital servo amplifiers JetMove D203, if I
f
(the
rated current of the line filter) is greater than the total current of the connected
servo amplifiers.
INFO 3
At overloading, the ballast resistor will become high-resistance. In this case, the
braking energy cannot be dissipated any more.