5 Technical Data
42 Jetter AG
Fig. 6: Typical power dissipation of the ballast resistor
Temperature of the JM-D203 Mounting Plate [°C]
Power Dissipation of the Ballast Resistor [W]
55
60
65
70
75
80
85
90
50 60 70 80 90 10040
WARNING
Danger resulting from electric shock!
In order to avoid electric shocks, earth the digital servo amplifier JetMove
D203 in either of the ways described below:
– At the bolt on the top side of the enclosure by a minimum cross-sectional
area of 10 mm²
or
– in two positions, namely at the bolt on the top side of the enclosure, and
at the PE terminal X1; for this, see chapter 1.2.3 "Earthing Procedure",
page 15.
To Next Page
Loading...
