Jetter JetMove D203 - Page 9

JetMove D203 Table of Contents
Jetter AG 9
12.6.1 Connecting to the RJ45 jack 105
12.6.2 Connection between -JC24X and PC 106
12.6.3 Connection between -JC24X, switch, and PC 106
12.6.4 Connection via several switches 107
12.7 Status LEDs, Mode Selector 109
12.7.1 LEDs 109
12.7.2 The mode selector 111
12.8 Setting the IP Address 112
12.8.1 Default IP address 112
12.8.2 IP address from the configuration memory 112
12.8.3 IP address based on the address switch position 114
12.8.4 Setting the IP address via special function 117
12.9 ON Delay 118
12.10 Interface Cables 119
12.10.1 Overview of interface cables 119
12.10.2 Serial programming cable 120
12.10.3 HMI cable for LCD 16 - 34 and 110 121
12.10.4 HMI cable KAY_0386-xxxx 122
12.10.5 HMI cable KAY_0533-0025 124
12.11 Anybus-CC 126
12.11.1 Installation instructions 126
12.11.2 Prying the break-away shield 126
12.11.3 Inserting the Anybus-CC module 127
13 Ordering Information 129
13.1 List of Documentation 129
13.2 Options 129
13.3 Motor Power Cable with Mating Connector SC 131
13.4 Resolver Cable 132
13.5 HIPERFACE Cable 132
13.6 System Bus Cables 132
List of Appendices
Appendix A: Recent Revisions 135
Appendix B: Glossary 136
Appendix C: List of Illustrations 139
Appendix D: Index 140