JLG E600 - Hub Assembly - Sheet 1 of 2

SECTION 3 - CHASSIS & TURNTABLE
3121813 – JLG Lift – 3-19
1A Spindle
1B Lip Seal
1C Tapered Bearing Cone
1D Tapered Bearing Cup
1E Tapered Bearing Cone
1F Ring Gear
1G Hub (Housing)
1H Stud
1J Reta ining Ring Ext.
1K Retaining Ring Int.
1L Spri ng (1.460,1.500)
1M Thrust Washer
1Q Seal Boot
2 Thrust Space r
3A Input Carrier
3B Thr ust Washer
3C Needle Bearing
3E Planet Shaft
3F Planet Gear
4A Output Carrier
4B Thr ust Washer
4C Needle Bearing
4D Thrust Spacer
4E Planet Shaft
4F Planet Gear
4G Ro ll P in
4H Thrust Washer
5 Retaining Ring - Ext
6A Cover
6B Disengage Cap
6C Bolt, Hex (.250-20 Unc, .500 Gr5)
6D Dowel Pin
6E O-ring
6F Pipe Plug
6G Retaining Ring - Int 7.086
7 Coupling
9 Input S haft
10 Input Sun Gear
11 Output Sun Gear
15 ID Pl ate
16 Dri ve Screw
17 O-r in g
18 O-r in g
19 Bolt, Flat Head - Hex Skt (.375-16)
20 Retainin g R ing - Ext.
Figure 3-10. Hub Assembly - Sheet 1 of 2