JohnBean B 500 - Page 64

64
5.7 ERROR CODES ON INTEGRATED DISPLAY
0X001001 PO NOT FOUND
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Check the main shaft Optoencoder cable
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001002 PO READING
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C86, C115, C84, C88
0X001003 PO WRITING
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Check the main shaft Optoencoder cable
If the problem still persists:
Check the main shaft Optoencoder.
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001004 PO EEP1 RD
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C86, C115, C84, C88