3
TABLE OF CONTENTS
CHAPTER 1 INTRODUCTION PAG. 6
1.1 GENERAL PAG. 6
1.2 TOOLS REQUIRED PAG. 6
1.3 IMPORTANT SAFETY INSTRUCTION PAG. 8
1.4 ELECTRICAL SAFETY PRECAUTION PAG. 8
CHAPTER 2 AC/DC POWER DISTRIBUTION PAG. 9
2.1 LOCKOUT AND/OR TAGOUT SYSTEM PROCEDURE PAG. 9
2.2 ELECTRICAL REQUIREMENTS PAG. 9
2.3 AC THEORY OF OPERATION PAG. 9
2.4 DC THEORY OF OPERATION PAG. 10
2.5 FUNCTIONAL DESCRIPTION PAG. 10
2.6 INSTALLATION PRECAUTIONS (Floor Level) PAG. 11
CHAPTER 3 BALANCERS COMPONENTS PAG. 12
3.1 INTRODUCTION PAG. 12
3.2 INTEGRATED DISPLAY PANEL PAG. 12
3.3 POWER ENTRY MODULE PAG. 14
3.4 INTEGRATED DISPLAY BOARD PAG. 14
3.5 CAPACITORS PAG. 14
3.6 KEYPAD PAG. 14
3.7 VPM VIBRATORY ASSEMBLY PAG. 15
3.8 TRANSDUCERS PAG. 15
3.9 TEMPERATURE SENSOR PAG. 16
3.10 INCREMENTAL ENCODER PAG. 16
3.11 ENCODER BOARD OF THE MAIN SHAFT PAG. 16
3.12 ENCODER BOARD OF THE POWER CLAMP PAG. 17
3.13 MOTOR DRIVE SYSTEM PAG. 18
3.14 BELT TENSION PAG. 18
3.15 THE BRAKES PAG. 18
3.16 BRAKING BY REVERSING THE MOTOR TORQUE PAG. 19
3.17 THE SHAFT LOCKS OF THE MOTOR DRIVE VIBRATORY ASSY PAG. 19
3.18 THE ELECTROMAGNETIC BRAKE PAG. 19
3.19 POWER CLAMPING DEVICE PAG. 19
3.20 SD SAPE (SEMI AUTOMATIC PARAMETER ENTRY) PAG. 20
3.21 SONAR WHEEL DATA SYSTEM PAG. 21
3.22 LASER SENSOR PAG. 21
3.23 WEIGHT LASER BOARD PAG. 21
CHAPTER 4 SERVICE PAG. 22
4.1 INTRODUCTION PAG. 22
4.2 POWER SUPPLY CABLE : CHECK AND REPLACEMENT PAG. 22
4.3 TO ACCESS TO THE INTEGRATED DISPLAY AND TO THE
INSIDE OF THE MACHINE PAG. 22
4.4 CHECK POWER TO INTEGRATED DISPLAY BOARD PAG. 23
4.5 CHECK AND REPLACEMENT POWER ENTRY MODULE PAG. 23
4.6 CHECK AND REPLACEMENT POWER ENTRY MODULE 6.3A FUSES PAG. 25
4.7 CHECK AND REPLACEMENT OF THE INTEGRATED DISPLAY
F1 AND F2 FUSES PAG. 25
4.8 CHECK OF THE POWER SUPPLY VOLTAGE PAG. 26
4.9 CHECK AND REPLACEMENT OF THE INTEGRATED DISPLAY PAG. 26
To Next Page
Loading...