JohnBean B 500 - User C Codes Reference

86
6.5 USER C CODES REFERENCE
C0 Load confi guration from default profi le
Options:
0 : No action
1 : Set default values
Special function: None
Description: Pressing the Acknowledgment key resets the user settings to values de! ned under factory setting
pro! le (default values). The chosen mode of operation can be transferred to the permanent memory
The following modes of operation are activated simultaneously by pressing the Acknowledgment key.
FUNCTION STATUS / VALUE CODE
Unbalance display Dynamic
Wheel Dimansion
distance = 115mm (SAPE)
diameter = 15"
width = 6,5"
Wheel type Car in inches Type 1
Weight placement Normal
Measurement units of the unbalance readings Grams / Ounces 0 / 1 C3
Compensation of adaptor unbalance Off 0 C4
Threshold for unbalance suppression in grams/
ounces
3.5 -20 g
0.12 - 0.71 oz
C8
Unclamping of power clamp locked 0/1 0 C22
Actuation direction of pedal for clamping/releasing 0/1 0 C26
Comments: None
C3 Measurement units of unbalance readings
Options:
0 : Readings in gram
1 : Readings in ounce
Special function:None
Description: The state de! nes the measurement unit of the unbalance readings (gram/ounce) active after power-
on and execution of C0.
The chosen mode of operation can be transferred to the permanent memory.
Comments: None
C4 Compensation of adaptor unbalance
Options: None
Special function: None
Description: Set code C4, close the wheel guard and start an extended measuring run by lowering the wheel
guard. After the measuring run state switches automatically to 1, the adaptor symbol comes up and the mode is quit.
Resetting the state to 0 cancels compensation of adaptor unbalance.