87
Compensation is also cancelled by calibration, readjustment by the operator, an optimisation run or by turning off the
machine.
Comments: None
C8 Treshold value of suppression of minor unbalance reading in units selected with C3
Options:
3.5 - 20g (0.12 - 0.71oz) : Threshold value
3.5g (0.12oz) : Factory-adjusted value
Special function: None
Description: To set a new value use the option selection. Finally press the Acknowledgment key to acknowledge
the entered value or press the Abort key to retain the former one.
To keep balance quality independent of weight placement, the OK indication is only visible if the unbalance readings
for the normal balancing mode (balance clips on rim ! anges) and the static unbalance are lower than the thresholds
set via C8. Therefore the rim width must be known for a correct assessment of the balance quality (and for
recommendation of optimisation).
If OK is displayed the unbalance readings will always be 0, irrespective of the selected balancing mode. If the
precision/FINE key is now pressed to disable the suppression of minor unbalance readings temporarily, this may result
in unbalance readings that are higher than the threshold in other than the normal balancing mode. This is due to the
fact that larger balance weights are usually required for adjacent correction planes and small diameters in the rim disc.
The threshold value can be transferred to the permanent memory.
Comments: The unit of measurement is chosen according to the one set with C3.
C11 Position brake after measuring run (Power Clamp)
Options
0 : No position brake after measuring run
1* : Position brake after measuring run for left plane
2 : Position brake after measuring run for right plane
Special function: None
Description: The position brake stops the main shaft in or near the correction position by initiating a braking pulse.
The position brake will be active after setting the on state and after a measurement run has been carried out with an
unbalance display for the correction plane exceeding the threshold value.
Option = 1: After the measurement run the wheel is braked for the left-hand correction plane. If the unbalance in the
left-hand correction plane is smaller than the threshold, the wheel will be braked for the right-hand correction plane.
Indexing of the wheel for the right-hand correction plane is initiated by "RETURN" key while the wheel guard is open.
Option = 2: After the measurement run the wheel is braked for the right-hand correction plane. If the unbalance in the
right-hand correction plane is smaller than the threshold, the wheel will be braked for the left-hand correction plane.
Indexing of the wheel for the left-hand correction plane is initiated by lpressing the "RETURN" key while the wheel
guard is open.
With p-variants and manual indexing of the wheel with open wheel guard, a braking pulse will be initiated shortly
before reaching one of the correction positions.
The selected mode of operation is transferred to the permanent memory.
Comments: The asterisk “*“ marks the factory-adjusted default
To Next Page
Loading...