JohnBean B 500 - C- Beeps of the Module;Object; D- Pause between the Cycles

83
5.9.5 -C- BEEPS OF THE MODULE/OBJECT
Beep sequence Description ID MODULE
S
Initialisation of the I2C bus fails.
22
SDA or SCL level is wrong
S S S S
Initialisation of keyboard device driver (including STOP,
wheel guard, pedal)
44, 45, 46, 47, 48
Resource not available (timer)
L L
Persistent object not available
29
Persistent object not available
L L S
External AD converter
25
Persistent object not available
L L S S
Internal AD converter
26
L L S S S
Temperature measurement
27
Persistent object not available
Resource not available (timer)
L L 4S
Incremental encoder of power clamp
2A
Persistent object not available
L L 5S
Data conditioning
42
Persistent object not available
3L
Extensions: keyboard/display, SAPE, brake, motor
44, 45, 46, 47, 48
Persistent object not available
Resource not available (timer)
3L S
Extensions: Drive system
49
Persistent object not available
Resource not available (timer)
5.9.6 -D- PAUSE BETWEEN THE CYCLES
P3 : 3 seconds pause
Example:
* * P0.5 S P1 5S P3 * * P0.5
2 init beeps with half a
second pause after
One short beep and a one
second pause
5 short beeps 3 seconds pause NEXT cycle ...
Ø Error during initialisation of the persistent objects. e.g. the Optoencoder board is not connected.