63
5.6 “H” ERROR CODES
H0 Optimisation Can't Improve
Press ESC button and balance the wheel again without perform the optimization because the whe-
el running conditions cannot be improved.
H1 Optimisation Not Recommended
Further optimization not recommended but feasible
H2 Optimisation Recommend Minimisation
Weight minimisation is recommended, optimisation can achieve no further improvement
H15 Power Clamp Disabled
Enable power clamp with C23
H20 Sape Can't Relocate
Measure the correction plane and switch to dynamic unbalance reading.
H21 Sape Position Not Matched
Index the correct position for this correction plane prior to ! tting the adhesive weight.
H23 Unclamp Denied
Enable power clamp with C23
H32 Plane Separation Too Small
Move gauge arm back into the home position. Then bring it once again to the application point for
weight placement encreasing the separation plane among inner and outer plane.
H80 User Calibration Not Provised
Check if the calibration weight is attached.
If the problem still persists:
Check if the calibration weight is attached in the correct side.
If the problem still persists:
Check if the calibration weight is correct
H82 Selftest Disturbed
Turn the machine off and back on without touch the unit.
H92 Sape1 Defective
2D sape not at home position, disconnected or out of calibration. Check with C80 and C92
To Next Page
Loading...