65
0X001005 PO EEP2 RD
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the Optoencoder.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001006 PO EEW1 WR
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C codes C74, C75, C86, C115, C84, C88
0X001007 PO EEW2 WR
Turn off and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C codes C74, C75, C85, C86, C122, C115, C84, C88
0X001010 KEYBOARD DISPLAY
The microprocessor has to ! nd the keyboard and communicate with it while balancer is working. If
something is wrong with that this diagnostic codes is generated by balancing kernel software. I2C
communication failure.
Check the plugs, connectors and cable wiring from power interface board to the key board. May
have to replace the integrated panel assembly if you can not ! nd anything wrong in wiring system.
C codes C45
0X001011 KEYBARD VOLTAGE
The microprocessor has to ! nd the keyboard and communicate with it while balancer is working. If
something is wrong with that this diagnostic codes is generated by balancing kernel software. I2C
communication failure.
Check the plugs, connectors and cable wiring from power interface board to the key board. May
have to replace the integrated panel assembly if you can not ! nd anything wrong in wiring system.
C codes C45
To Next Page
Loading...