90
6.6 SERVICE C CODES REFERENCE
C0 Load confi guration from default profi le
Options:
0 : No action
1 : Set default values
Special function: None
Description: Pressing the Acknowledgment key resets the user settings to values de! ned under factory setting
pro! le (default values). The chosen mode of operation can be transferred to the permanent memory
The following modes of operation are activated simultaneously by pressing the Acknowledgment key.
FUNCTION STATUS / VALUE CODE
Unbalance display Dynamic
Wheel Dimansion
distance = 115mm (SAPE)
diameter = 15"
width = 6,5"
Wheel type Car in inches Type 1
Weight placement Normal
Measurement units of the unbalance readings Grams / Ounces 0 / 1 C3
Compensation of adaptor unbalance Off 0 C4
Threshold for unbalance suppression in grams/oun-
ces
3.5 -20 g
0.12 - 0.71 oz
C8
Unclamping of power clamp locked 0/1 0 C22
Actuation direction of pedal for clamping/releasing 0/1 0 C26
Comments: None
C12 Recall counter
Options:
Only press the +/- key, do not turn the wheel)
1 : Total number of measuring runs
2 : Number of measuring runs where balance quality was considered OK
3 : Number of optimisations or minimisations
4 : Number of measuring runs in service mode
5 : Number of measuring runs since the last calibration
6 : Total number of clamping operations (p models only)
Special function: None
Description: Various counter readings
Comments: This mode has been adjusted to usual sequences of operation.
To Next Page
Loading...