66
0X001012 KEYBOARD READING
The microprocessor has to ! nd the keyboard and communicate with it while balancer is working. If
something is wrong with that this diagnostic codes is generated by balancing kernel software. I2C
communication failure.
Check the plugs, connectors and cable wiring from power interface board to the key board. May
have to replace the integrated panel assembly if you can not ! nd anything wrong in wiring system.
C codes C45
0X001020 DC OVERRUN
Check if the main shaft turns free.
If the problem still persists:
Check if the brake is correctly adjusted.
If the problem still persists:
Check the main shaft Optoencoder
If the problem still persists:
Check the main shaft polygonal ring.
If the problem still persists:
Call Snap On
C codes C74, C75, C85, C86, C115, C84, C88
0X001021 IEM ZERO MISMATCH
Check wing nut
If the problem still persists:
Check the shaft.
If the problem still persists:
Check the wheel clamping.
If the problem still persists:
Check the main shaft Optoencoder " at cable.
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001022 IEP ZERO MISMATC
Check the derive pulley Optoencoder adjustment.
If the problem still persists:
Check the derive pulley Optoencoder.
If the problem still persists:
Check if the drive pulley moves side to side.
If the problem still persists:
Call Snap On
C Codes C98
To Next Page
Loading...