JohnBean B 500 - Page 77

77
0X001094 CLAMP LOCKED
Check the Power Clamp pedal.
If the problem still persists:
Check the drive Pulley Optoencoder
If the problem still persists:
Check the brake pads
If the problem still persists:
Check the electromagnetic brake
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C Codes C56, C74, C97, C98, C115, C84, C88, C122,
0X001095 CLAMP SLIP
Check the Power Clamp pedal.
If the problem still persists:
Check the drive Pulley Optoencoder
If the problem still persists:
Check the brake pads
If the problem still persists:
Check the electromagnetic brake
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C Codes C56, C74, C97, C98, C115, C84, C88, C122,
0X001096 CLAMP FALL BACK
Check the drive pulley
If the problem still persists:
Check the power clamp tie rod
If the problem still persists:
Check the electromagnetic brake
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C Codes C56, C74, C97, C98, C115, C84, C88, C122,