JOHNSON CONTROLS
69
23
FORM 155.17-N1
ISSUE DATE: 4/1/2013
Along with the burn er’s ship loose parts is a Pow er
Flame-supplied ther mo cou ple probe as sem bly and a
50' roll of “J” ther mo cou ple wire. This probe must be
field installed into the chimney breech ing be fore the
man u al backdraft damp er, if pos si ble. If this is not pos-
si ble, the probe should be as close as pos si ble down-
stream of the manual backdraft damp er. The probes
wires must be connected to the temperature controller
in the burner panel. The probe will require a 1/8" NPTI
coupling, which must be sup plied by the field in stall er.
SECTION 23 – HIGH STACK TEMPERATURE PROBE
To Next Page
Loading...
