Johnson Controls YORK YPC Series - FIGURE 45 - Rigging for 16 G through 18 G Direct-Fired Units; FIGURE 46 - Rigging for 19 G through 19 Gl Direct-Fired Units

JOHNSON CONTROLS
96
APPENDIX B - RIGGING ILLUSTRATIONS
FORM 155.17-N1
ISSUE DATE: 4/1/2013
NOTE: For lifting units, sling vertically. Use extreme care so as not to sling against, or on any projecting brackets, pipes, ttings, etc. Use four
slings, one on each end of the high-temperature generator and one at each end of the main shell. When lifting, keep unit level.
LESS THAN 60°
FIGURE 45 - RIGGING FOR 16G THROUGH 18G DIRECT-FIRED UNITS
LD05333
NOTE: For lifting units, sling vertically. Use extreme care so as not to sling against, or on any projecting brackets, pipes, ttings, etc. Use four
slings and spreader bar as shown, one sling on each end of the rst-stage generator and one on each end of the main shell.
BURNER END
EXHAUST END
FIGURE 46 - RIGGING FOR 19G THROUGH 19GL DIRECT-FIRED UNITS
LD05334