EasyManua.ls Logo

JUKI DDL-9000C-S Series - Page 122

JUKI DDL-9000C-S Series
198 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
No. Item Setting range Unit
Initial value
SMS SSH FMS FSH
SMS CE
SSH CS FMS CE FSH CE
U035
Minimum speed of the pedal
The maximum number of revolutions during thread trimming
differs with the machine head.
150 to Max.
of thread
trimming
sti/min 200 200 200 200 200 200 200 200
U036
Speed during thread trimming
The maximum number of revolutions during thread trimming
differs with the machine head.
150 to Max.
of thread
trimming
sti/min 300 220 300 220 300 220 300 220
U037
Speed during soft start
The maximum number of revolutions during soft start differs with
the machine head.
The number of revolutions set with this memory switch is given
precedence even if it is lower than the lowest speed by pedal.
100 to Max sti/min 800 800 800 800 800 800 800 800
U038
Speed during one-shot stitching
The maximum number of revolutions during soft start differs with
the machine head.
100 to Max sti/min 2500 2500 2500 2500 2500 2500 2500 2500
U039
Start position of rotation
10 to 5000 - 600 600 600 600 600 600 600 600
U040
Start position of acceleration
10 to 1000 - 900 900 900 900 900 900 900 900
U041
Start position of lifting of presser foot
500 to −10 - 100 100 100 100 100 100 100 100
U042
Start position of lowering of presser foot
10 to 500 -
300 300 300 300 300 300 300 300
U043
Start position of thread trimming
1000 to −100
- 840 840 840 840 840 840 840 840
U044
Position that maximum sewing speed is reached
10 to 15000 - 4000 4000 4000 4000 4000 4000 4000 4000
U045
Pedal neutral-position correction value
150 to 150 - 0 0 0 0 0 0 0 0
U047
Presser-foot lift nishing position
The position to which the presser foot goes up when the back
part of the pedal is depressed to its rst step. (1st-step spring
position)
1000 to
100
- 600 600 600 600 600 600 600 600
U049
Presser foot lowering time
The initial value differs with the machine head.
0 to 500 ms 100 100 100 100 100 100 100 100
U051
Correction of turning-ON of reverse feed stitching (at start)
50 to 50
Degree
0 0 0 0 0 0 0 0
– 106 –

Table of Contents

Related product manuals