5
1 Introduction
1.1 Preface
Please read these Operating Instructions before commissioning the instru-
ment. Keep the operating instructions in a place which is accessible to all us-
ers at all times.
Please assist us to improve these operating instructions where necessary.
Your suggestions will be most welcome.
Phone in Germany (0661) 6003-725
abroad (+49) 661 6003-0
Fax in Germany (0661) 6003-681
abroad (+49) 661 6003-607
H
All necessary settings are described in this manual. If any difficul-
ties should still arise during commissioning, you are asked not to
carry out any unauthorized manipulations on the unit. You could
endanger your rights under the instrument warranty!
Please contact the nearest subsidiary or the main factory in such a
case.
E
When returning modules, assemblies or components, the regula-
tions of EN 100 015 “Protection of electrostatically sensitive com-
ponents” must be observed. Use only the appropriate ESD pack-
aging for transport.
Please note that we cannot accept any liability for damage caused
by ESD (electrostatic discharge).
B
To Next Page
Loading...
