59
4 Configuration parameters
4.2.6 Configuration - Measurement storage
Reset generation Configuration
➔ Counter/Integrator
➔ Reset generation
Off,
Logic inp1 — 4,
Logic channel 1 — 6,
Low alarm 1 — 6,
Low comb. al.,
High alarm 1 — 6,
High comb. al.,
Counter/I al. 1 — 6,
C/I comb. al.,
Comb. alarm,
Memory al.,
Error,
Modbus-Flag
Determine the event which
will reset all counter and
integrator counts (with-
out storing).
v See “External reset” on
page 16.
Parameter Value/selection Description
Store status
normal operation
Configuration
➔ Meas. storage
➔ Normal operation
➔ Store status
Off,
On
Stored value
normal operation
Configuration
➔ Meas. storage
➔ Normal operation
➔ Stored value
Average val.,
Instant. val.,
Minimum,
Maximum,
Peak value
v Chapter 2.7 “Operating
modes”
Chapter 2.8 “Data
storage”
Storage rate
normal operation
Configuration
➔ Meas. storage
➔ Normal operation
➔ Storage rate
1—60 — 32767s v Chapter 2.7 “Operating
modes”
Chapter 2.8 “Data
storage”
Operating signal
event operation
Configuration
➔ Meas. storage
➔ Event operation
➔ Operating signal
Off,
Logic inp1 — 4,
Logic channel 1 — 6,
Low alarm 1 — 6,
Low comb. al.,
High alarm 1 — 6,
High comb. al.,
Counter/I al. 1 — 6,
C/I comb. alarm,
Comb. alarm,
Memory al.,
Error,
Modbus-Flag
When the configured signal
is active, the instrument
switches to event opera-
tion.
Stored value
event operation
Configuration
➔ Meas. storage
➔ Event operation
➔ Stored value
Average val.,
Instant. val.,
Minimum,
Maximum,
Peak value
v Chapter 2.7 “Operating
modes”
Chapter 2.8 “Data
storage”
Storage rate
event operation
Configuration
➔ Meas. storage
➔ Event operation
➔ Storage rate
1—5 — 32767s v Chapter 2.7 “Operating
modes”
Chapter 2.8 “Data
storage”
To Next Page
