2 Instrument description
12
Channel line
(channel
representation)
The channel line shows the measurements of the active channels and their unit
as
- measurement
-scaling or
-bargraph.
Alternatively, the header can be switched off altogether.
In addition, alarms and out-of-limit conditions are made directly visible, ac-
cording to the display mode.
Example: Measurement (meas. small)
The selection and visual presentation of the channel line can be controlled by
using the parameter Parameters ➔ Diagram view ➔ Channel representation.
2.3 Analog inputs
Internal
analog inputs
The paperless recorder can be equipped with 3 or 6 analog inputs. When con-
figuring the analog inputs (Chapter 4.2 “Table of configuration parameters”),
these are designated analog input 1 — 3 (1 — 6).
Numerical display
The measurements are shown in numerical form.
OFF
If a channel is switched off, then
there will be no indication.
Unit of measurement
Alarm
If an alarm is present (e. g. out-of-limit), the measurement
of the channel is shown on a red background.
Overrange
Underrange
State of
event traces
To Next Page
Loading...
