To Next Page

To Previous Page

03.09 EN

duced to 2.5 km/h (slow travel) when the truck travels over the permanent magnets

in the ground (normally at the end of a narrow aisle or in the transfer aisle. The end

of aisle safety device indicator (16) lights up.

Z The travel speed reduction is activated whenever the truck travels over ground

magnets, irrespective of the travel direction and the order in which the magnets are

passed over.

Press the Reset button (17) to resume with normal travel speed. The indicator (16)

goes out again.

Z On trucks with the end of aisle safety device option, the latter is automatically acti-

vated when the truck is switched on (indictor (16) lit). In order to travel at normal

speed after the truck has been switched on, the Reset button (17) must therefore

be pressed (indicator (16) goes out).

Z The end of aisle safety device is an additional function designed to support the op-

erator, but which does not release him from his responsibilities such as to monitor

braking at the aisle end and if necessary to apply the brakes. Alternatively, the end

of aisle safety device can cause the truck to brake to a halt instead of reducing trav-

el speed to 2.5 km/h. Contact the manufacturer’s service department if you wish

this alteration to be performed.