08.11 EN
100
6.3 Panel door
CAUTION!
An open door can cause accidents (123)
XDo not travel with an open door (123). When opening the door make sure there is
nobody in the door’s swing range.
XAlways close the door tightly and make sure it is locked.
XClosing the door does not release the driver from his responsibility to wear a seat
belt, (see "Seat Belt" on page 68).
Hazardous situations
If the truck is about to tip over, do not loosen the
seat belt. The driver must not jump off the truck.
The driver must lean his upper body over the
steering wheel and hold on with both hands. Tilt
your body in the opposite direction of fall.
Requirements
– On trucks with a door monitoring sensor, travel
is only enabled when the panel door is closed
(o).
Procedure
• Pull the handle (127) towards the operator
position, the door swings open.
• Pull the door (123) towards the driver; the door
closes.
6.4 Operator position extension
DANGER!
Altering the tilt resistance can be dangerous
The lateral tilt resistance reduces with a higher truck centre of gravity.
The height above the overhead guardincreases by 300 mm.
XAdapt the travel speed, in particular when cornering.
Z For entry and exit (see "Entry and exit" on page 63).
123127
To Next Page
Loading...
Need help?
General
