179
08.11 EN
7.10 Seat belt maintenance
Check the safety restraint belt
Procedure
• Pull out the belt completely and check for fraying
• Test the belt buckle and make sure the belt returns correctly into the retractor.
• Check the cover for damage.
Testing the automatic blocking system
Procedure
• Park the truck on a level surface.
• Pull out the seat belt with a jerk
Z The interlock must prevent the belt from coming out.
The seat belt service is now complete.
DANGER!
A faulty seat belt can cause injury
Using a faulty seat belt can result in injury.
XOnly operate the truck with the seat belt intact. A faulty seat belt should be replaced
immediately.
XThe truck must remain decommissioned until a functional seat belt has been fitted.
7.11 Transmission
WARNING!
It is important to check the oil level correctly. The oil acts as a lubricant and
coolant and also serves to transfer force. A low oil level results in loss of drive
power and causes gearbox damage due to overheating.
7.11.1 Checking the transmission oil level
Z Only use clean, fresh oil from clean
containers to fill or top up the transmission.
Damage will arise from contamination or
water entering the transmission.
Z You access the transmission oil dipstick on
the right-hand side of the transmission
(looking in the direction of travel).
Z Always check the transmission oil level at
operational temperature
Procedure
• Park the truck securely on a level surface and start the engine.
• While the engine is running in idle, remove the dipstick (157).
183
157
To Next Page
Loading...
Need help?
General
