43
08.11 EN
4 Using the Truck for the First Time
Safety Instructions for Assembly and Commissioning
WARNING!
Accident risk from incorrect assembly
The assembly of the truck at the application site, commissioning and driver training
must only be performed by the manufacturer's customer service representatives who
have been specially trained for these tasks.
XThe hydraulic lines may only be connected to the basic truck / mast interface when
the mast has been properly assembled.
XOnly then can the truck be started.
XIf several trucks have been delivered, make sure that the serial numbers of the load
handlers, masts and basic trucks always match.
Preparing the truck for operation after delivery or transport
Procedure
• Check the equipment is complete.
• Check the engine oil level.
• Check the hydraulic oil level. Check the transmission oil level (only on trucks with
hydrodynamic drives).
• Check the brake fluid level (only on trucks with hydrodynamic drives).
• Test the battery connections.
• Check the battery acid level (not for maintenance-free batteries).
The truck can now be started, (see "Preparing the Truck for Operation" on page 62).
To Next Page
Loading...
Need help?
General
