08.11 EN
180
• Wipe the dipstick with a lint-free cloth and put in back fully into its port.
• Remove the dipstick again and check whether the oil level is between the MIN and
MAX markings.
• If the level is below the centre point, add transmission oil through the filler port (183)
until it reaches the MAX marking on the dipstick.
• Refit the dipstick in the port.
7.12 Brake
7.12.1 Checking the parking brake
The parking brake (73) must be able to
hold the truck plus the maximum load on
an incline of 15%. If it cannot, the parking
brake must be adjusted. Please contact
Jungheinrich customer services in this
case.
7.12.2 Checking the brake fluid level
Procedure
• Undo the screws of the left-hand panel
(184).
• Remove the panel (184).
• Check the brake fluid level in the brake fluid reservoir (185).
• The brake fluid level should lie between the MIN and MAX markings.
• If necessary, add brake fluid.
Capacity: 0.25 l
• After adding brake fluid, refit the panel.
73
184
185
To Next Page
Loading...
Need help?
General
