08.11 EN
68
3.5 Seat Belt
DANGER!
Travelling without a seat belt increases the risk of injury.
If the seat belt is not worn or is modified, personal injury can result.
XAlways put on the seat belt before starting the industrial truck.
XDo not modify the seat belt.
XDamaged or non-operational seat belts must be replaced by trained personnel.
XSeat belts must always be replaced after an accident.
XOnly original spare parts must be used for retrofits or repairs.
Z Protect the seat belt from contamination (e.g. cover it when the truck is idle) and
clean it regularly. Frozen belt locks or pulleys must be thawed out and dried to
prevent them from freezing up again.
The temperature of the warm air should not exceed +60 °C!
Starting the industrial truck on steep slopes
The automatic blocking system locks the belt in the retractor when the truck is
positioned on a steep slope. This prevents the belt from being pulled out of the
retractor.
Z Carefully drive the truck off the slope and then put on the belt.
To Next Page
Loading...
Need help?
General
