NOTE: You must also configure multichassis link aggregation (MC-LAG)
when you configure the admin-key.
fast-failover—Specify to override the IEEE 802.3ad standard and allow the standby link
to receive traffic. Overriding the default behavior facilitates subsecond failover.
passive—Respond to LACP packets.
The remaining statements are explained separately.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring Aggregated Ethernet LACP
• Configuring Aggregated Ethernet LACP (CLI Procedure) on page 86
• Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between an
EX4200 Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
Copyright © 2015, Juniper Networks, Inc.196
Network Interfaces for EX4300 Switches