Juniper MX150 - Chapter 12 Connecting the MX150 to the Network; Connecting an MX150 to a Network for Out-Of-Band Management; Figure 18: Connecting an MX150 to a Network for Out-Of-Band Management

CHAPTER 12
Connecting the MX150 to the Network
•
Connecting an MX150 to a Network for Out-of-Band Management on page 89
•
Connecting an MX150 to a Management Console on page 90
•
Connecting an MX150 to a Management Console Using Mini-USB Type-B Console
Port on page 91
Connecting an MX150 to a Network for Out-of-Band Management
You can monitor and manage the MX150 by using a dedicated management channel.
The MX150 has one management port, eight 1-Gigabit Ethernet RJ-45 ports, two 1-Gigabit
Ethernet RJ-45 network or uplink ports, two1-Gigabit Ethernet small form-factor pluggable
(SFP) ports, and two 1/10-Gigabit Ethernet SFP+ ports. Use the management port to
connect the MX150 device to a network for out-of-band management.
Ensure that you have an appropriate cable available.
To connect an MX150 to a network for out-of-band management (see
Figure 18 on page 90):
1. Connect one end of the cable to the management port (labeled MGMT) on the MX150.
2. Connect the other end of the cable to the management switch (see
Figure 18 on page 90).
89Copyright © 2017, Juniper Networks, Inc.