1. Power off the MX150 and remove the power cables. See “Powering Off an MX150” on
page 97.
2. Remove the cables that connect the device to all external devices.
3. Remove all field-replaceable units (FRUs) from the MX150.
4. Have one person support the weight of the device while another person unscrews and
removes the mounting screws.
5. Remove the device from the rack or cabinet (see “Chassis Lifting Guidelines for MX150”
on page 130) and place the device in an antistatic bag.
6. Place the device in the shipping carton.
7. Place the packing foam on top and around the device.
8. If you are returning accessories or FRUs with the device, pack them as instructed in
“Packing a MX150 Router or Component for Shipping” on page 111.
9. Replace the accessory box on top of the packing foam.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing MX150 Components for Shipping
CAUTION: Do not stack the MX150 components. Return individual
components in separate boxes if they do not fit together on one level in the
shipping box.
To pack and ship MX150 components:
•
Place individual FRUs in antistatic bags.
•
Ensure that the components are adequately protected with packing materials and
packed so that the pieces are prevented from moving around inside the carton.
•
Close the top of the cardboard shipping box and seal it with packing tape.
•
Write the RMA number on the exterior of the box to ensure proper tracking.
Related
Documentation
Returning a MX150 Router or Component for Repair or Replacement on page 109•
Copyright © 2017, Juniper Networks, Inc.112
MX150 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
