•
Ensure that the hyper terminal properties of the console server or laptop are set as
follows:
•
Baud rate—9600
•
Flow control—None
•
Data—8
•
Parity—None
•
Stop bits—1
•
DCD state—Disregard
Ensure that you have the following parts and tools available:
•
1 mini-USB cable with Standard-A and Mini-USB Type- B (5-pin) connectors (not
provided).
To connect the MX150 to the console by using Mini-USB Type-B console port:
1. Connect the Standard-A connector of the mini-USB cable to the host machine (PC
or Laptop).
2. Connect the Mini-USB Type-B (5-pin) connector of the mini-USB cable to the Mini-USB
Type-B console port (labeled CON) on the MX150.
3. Setthe Mini-USB Type-B console port asthe active console port by using the command
port-type.
For information about configuring the console port type, see Configuring the Console
Port Type (CLI Procedure).
4. Reboot the MX150.
After the connection is established, the Mini-USB Type-B becomes the active console
port. The host machine connected to the Mini-USB Type-B console port displays log
messages and lets you control MX150 functionality through it.
Related
Documentation
• Console Port Connector Pinouts for MX150 on page 32
• Connecting an MX150 to a Network for Out-of-Band Management on page 89
Copyright © 2017, Juniper Networks, Inc.92
MX150 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
