5. (Optional) Configure the name of the device. If the name includes spaces, enclose
the name in quotation marks (“ ”).
[edit]
root@host# set system host-name host-name
6. Configure the IP address and prefix length for the device management interface.
[edit]
root@host# set interfaces fxp0 unit 0 family inet address address/prefix-length
fxp0 is the management interface.
To configure an IPV6 address, run the root@host# set interface fxp0 family inet6
address address v6_address.
NOTE: fxp0 is found on the front panel of the MX150 device.
7. Configure the default gateway.
[edit]
root@host# set routing-options static route default next-hop address
8. Enable the SSH service.
[edit]
root@host# set system services ssh
9. Enable the Telnet service.
[edit]
root@host# set system services telnet
10. Commit the configuration to activate it on the device.
[edit]
root@host# commit
Related
Documentation
• Installing and Connecting an MX150 on page 77
Copyright © 2017, Juniper Networks, Inc.94
MX150 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
