Juniper SRX110 H2 - Changing Reset Config Button Behavior

system-services {
dhcp;
tftp;
}
}
}
}
screen untrust-screen;
}
}
policies {
from-zone trust to-zone untrust {
policy trust-to-untrust {
match {
source-address any;
destination-address any;
application any;
}
then {
permit;
}
}
}
}
}
vlans {
vlan-trust {
vlan-id 3;
l3-interface vlan.0;
}
}
protocols {
stp;
}
Related
Documentation
SRX110 Services Gateway Autoinstallation Overview on page 49•
• SRX110 Services Gateway Software Configuration Overview on page 83
• Performing Initial Software Configuration on the SRX110 Services Gateway Using the
CLI on page 96
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
CLI
This procedure connects the device to the network but does not enable it to forward
traffic. For complete information about enabling the device to forward traffic, including
examples, see the appropriate Junos OS configuration guides.
To configure the Junos OS:
1. Verify that the device is powered on.
2. Log in as the root user. There is no password.
Copyright © 2015, Juniper Networks, Inc.96
SRX110 Services Gateway Hardware Guide for H2 Model Numbers