Juniper SRX110 H2 - Chapter 5 Power Requirements and Specifications; SRX110 Services Gateway Site Electrical Wiring Guidelines

Table 9 on page 17 lists the back panel components of the SRX110 Services Gateway.
Table 9: SRX110 Services Gateway Back Panel Components
ComponentNumber
Cable tie holder1
3G-WAN USB port2
Lock3
Grounding point4
CompactFlash card5
Power supply unit6
Cable tie holder7
NOTE:
•
If there is any problem with the CompactFlash card, you must return the
services gateway for repair or replacement. For this, you need to contact
Juniper Networks Technical Assistance Center (JTAC).
•
The cable tie holder provides support for holding the power cord to the
power supply point.
•
The lock allows you to lock and secure the device to the installation site.
Related
Documentation
SRX110 Services Gateway Specifications on page 30•
• SRX110 Services Gateway Built-In Interfaces on page 17
• SRX110 Services Gateway LEDs on page 19
• SRX110 Services Gateway Power Supply on page 9
SRX110 Services Gateway Built-In Interfaces
Table 10 on page 18 summarizes the interface ports supported on the SRX110 Services
Gateway.
17Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Chassis Description