General Site Guidelines for Installing the SRX110 Services Gateway
The following precautions help you plan an acceptable operating environment for your
services gateway and avoid environmentally caused equipment failures:
•
The SRX110 Services Gateway requires unrestricted circulation of air to maintain an
optimal operating temperature. Allow sufficient clearance between the front and back
of the chassis and adjacent equipment. Ensure that there is adequate circulation in
the installation location.
•
Follow the electrostatic discharge (ESD) procedures to avoid damaging the equipment.
Static discharge can cause components to fail completely or intermittently over time.
NOTE: Install the deviceonly in restricted areas, such as dedicated equipment
rooms and equipment closets, in accordance with Articles 110–16, 110–17,
and 110–18 of the National Electrical Code, ANSI/NFPA 70.
Related
Documentation
SRX110 Services Gateway General Safety Guidelines and Warnings on page 131•
• SRX110 Services Gateway Rack Requirements on page 33
• SRX110 Services Gateway Cabinet Requirements on page 32
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX110 Services
Gateway on page 34
SRX110 Services Gateway Specifications
The SRX110 Services Gateway chassis is a rigid sheet metal structure of 1 rack unit (U)
height, which houses all the other hardware components.
Figure 8 on page 30 shows the SRX110 Services Gateway with 3G and VDSL2
(VDSL/ADSL-POTS).
Figure 8: SRX110 Services Gateway with 3G and VDSL2
(VDSL/ADSL-POTS)
Copyright © 2015, Juniper Networks, Inc.30
SRX110 Services Gateway Hardware Guide for H2 Model Numbers
To Next Page
Loading...
Need help?
General
