General Safety Guidelines and Warnings
The following guidelines help ensure your safety and protect the services gateway from
damage. The list of guidelines might not address all potentially hazardous situations in
your working environment, so be alert and exercise good judgment at all times.
•
Perform only the procedures explicitly described in this guide. Make sure that only
authorized service personnel perform other system services.
•
Keep the area around the chassis clear and free from dust before, during, and after
installation.
•
Keep tools away from areas where people could trip on them.
•
Wear safety glasses if you are working under any conditions that could be hazardous
to your eyes.
•
Do not perform any actions that create a potential hazard to people or make the
equipment unsafe.
•
Never install or manipulate wiring during electrical storms.
•
Never install electrical jacks in wet locations unless the jacks are specifically designed
for wet environments.
•
Do not open or remove chassis covers or sheet metal parts unless instructions are
provided in this guide. Such an action could cause severe electrical shock.
•
Do not push or force any objects through any opening in the chassis frame. Such an
action could result in electrical shock or fire.
•
Avoid spilling liquid onto the services gateway chassis or onto any services gateway
component. Such an action could cause electrical shock or damage the services
gateway.
•
Avoid touching uninsulated electrical wires or terminals that have not been
disconnected from their power source. Such an action could cause electrical shock.
Related
Documentation
General Electrical Safety Guidelines and Warnings on page 101•
• Maintenance and Operational Safety Guidelines and Warnings on page 95
Restricted Access Area Warnings
WARNING: The services gateway is intended for installation in restricted
access areas. A restricted access area is an area to which access can be
gained only by service personnel through the use of a special tool, lock and
key, or other means of security, and which is controlled by the authority
responsible for the location.
85Copyright © 2017, Juniper Networks, Inc.
Chapter 20: General Safety Guidelines and Warnings
To Next Page
Loading...
