3. Using both hands, place the power supply in the power supply slot on the rear panel
of the services gateway and slide it in until it is fully seated and the ejector lever fits
into place. You will hear a distinct click when the power supply is fully seated in the
chassis.
Figure 23: Installing a DC Power Supply
Related
Documentation
• Connecting DC Power to an SRX4100 Services Gateway on page 48
• Removing a DC Power Supply from an SRX4100 Services Gateway on page 71
73Copyright © 2017, Juniper Networks, Inc.
Chapter 18: Replacing DC Power Supplies
To Next Page
Loading...
