AC Power Cord Specifications for the SRX4100 Services Gateway
A detachable AC power cord is supplied with the AC power supplies. The coupler is type
C13 as described by International Electrotechnical Commission (IEC) standard 60320.
NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 14.75 ft) in length, to comply with National Electrical code
(NEC) Section 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3).
Table 19 on page 30 provides power cord specifications, and Figure 12 on page 30 depicts
the plug on the AC power cord provided for each country or region.
Table 19: AC Power Cord Specifications
Plug StandardsElectrical SpecificationCountry
AS/NZ 3112-1993250 VAC, 10 A, 50 HzAustralia
GB2099.1 1996 and
GB 1002 1996
(CH1-10P)
250 VAC, 10 A, 50 HzChina
CEE (7) VII250 VAC, 10 A, 50 HzEurope (except Italy and United Kingdom)
CEI 23-16/VII250 VAC, 10 A, 50 HzItaly
JIS 8303125 VAC, 12 A, 50 or 60 HzJapan
NEMA 5-15125 VAC, 10 A, 60 HzNorth America
BS 1363A250 VAC, 10 A, 50 HzUnited Kingdom
Figure 12: AC Plug Types
NOTE: Power cords and cables must not block access to services gateway
components or drape where people might trip on them.
CAUTION: The AC power cord for the services gateway is intended for use
with the services gateway only and not for any other use.
Copyright © 2017, Juniper Networks, Inc.30
SRX4100 Services Gateway Hardware Guide
To Next Page
Loading...
