Juniper SRX4100 - Figure 3: HA Port Leds; HA Port Leds; Network Port Leds; Chassis Components and Descriptions

Table 5: Management Port LEDs
DescriptionLED
•
Solid amber—A link is established, but there is no activity on the link.
•
Blinking amber—There is link activity.
•
Off—There is no link established.
Link/Activity (LED
on the left)
•
Solid green—100-Mbps link is established.
•
Solid amber—1000-Mbps link is established.
•
Off—There is no link established.
Speed (LED on the
right)
HA Port LEDs
Each HA port has one status LED located between the ports. Figure 3 on page 7 shows
the LEDs. The upper LED (callout 1) displays the status for the port on the right and the
lower LED (callout 2) displays the status for the port on the left. Table 6 on page 7
describes the LEDs.
Figure 3: HA Port LEDs
Table 6: HA Port LEDs
DescriptionLED
•
Solid amber—A link is established.
•
Blinking amber—There is link activity.
•
Off—There is no link established.
Status LED
Network Port LEDs
Each SFP+ port has two status LEDs located above the port. Table 7 on page 8 describes
the LEDs. Figure 4 on page 8 shows the LEDs.
7Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions