Juniper SRX4100 - Chapter 2 Chassis Components and Descriptions; Understanding the SRX4100 Services Gateway Front Panel; Figure 1: SRX4100 Services Gateway Front Panel; Table 3: SRX4100 Services Gateway Components on the Front Panel

CHAPTER 2
Chassis Components and Descriptions
•
Understanding the SRX4100 Services Gateway Front Panel on page 5
•
Understanding the SRX4100 Services Gateway Back Panel on page 8
•
Field-Replaceable Units in SRX4100 Services Gateways on page 9
Understanding the SRX4100 Services Gateway Front Panel
Figure 1 on page 5 shows the front panel of the SRX4100 Services Gateway.
Figure 1: SRX4100 Services Gateway Front Panel
Table 3 on page 5 lists the components on the front panel of the services gateway.
Table 3: SRX4100 Services Gateway Components on the Front Panel
DescriptionComponentNumber
Gigabit Ethernet port to connect to the device overthe network.Management port1
Two USB 2.0 ports that accept a USB storage device.USB ports2
Two 1-Gigabit Ethernet/10-Gigabit Ethernet ports, CTL (control
port) and FAB (fabric port), to synchronize data and maintain
state information in a chassis cluster setup. These ports
support enhanced small form-factor pluggable (SFP+)
transceivers.
HA ports3
Eight 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ ports for
network traffic.
SFP+ ports4
Indicate component and system status at a glance.LEDs5
5Copyright © 2017, Juniper Networks, Inc.